Go Back   CAE Healthcare Community Forum > Products and Applications > iStan

 
Thread Tools Display Modes
  #1  
08-13-2012, 07:03 AM
klewis klewis is offline
Junior Member
 
Join Date: Aug 2012
Posts: 1
Default chest tube

I am planning on doing the GSW simulation this coming Wednesday and have never primed the chest tube drainage on I-Stan. Any directions would be greatly appreciated. Thanks in advance Kathy
  #2  
08-13-2012, 09:21 AM
Tony Rita Tony Rita is offline
Junior Member
 
Join Date: Nov 2011
Posts: 7
Default Priming the Chest Tube Feature on iStan

KLewis,

Priming the Chest Tube Feature
The chest tube feature is primed and enabled using the Chest Tube Enable parameter located on the Respiratory view.
To prime the Chest Tube feature:
1. Ensure the on-board bleeding system is filled with fluid (for more information, see Preparing the On-Board Bleeding System on page 147 of your user guide (a PDF quick-link version is at the bottom left of your Home Screen on Muse).
2. Lubricate the provided chest priming tube with the silicone spray included with the simulator inventory kit.
3. Insert the chest priming tube into the simulator until resistance is met.
4. On the Respiratory view, select the Prime option under Chest Tube Enable: Left or Chest Tube Enable: Right or both, depending on need.
5. Once fluid begins to flow, remove the priming tube.
6. Prior to an actual chest tube insertion, select Enable under Chest Tube Enable: Left or Chest Tube Enable: Right or both, depending on the location(s) utilized.
Three additional parameters allow the user to set air flow and fluid rate as well as to determine the type of air leak:
Chest Tube Air Leak Flow - determines the quantity of air that drains with the chest tube output.
Chest Tube Air Leak Type - sets whether the leak is a pneumothorax or an air leak with the chest tube or the chest wall.
Chest Tube Flow - specifies the rate at which fluid can be removed from the simulated pleural space via a chest tube drainage system.
All three parameters are located on the Respiratory view under Additional Parameters.
The Intrapleural Volume parameter allows Intrapleural volume to accumulate, for example, as happens during pneumothorax, hydrothorax and hemothorax.
To simulate a pneumothorax, set the corresponding Intrapleural volume to a value greater than 0 ml. Values above 500 mL reduce the corresponding lung volume significantly. Breath sounds are automatically diminished on the appropriate side due to decreased ventilation of the affected lung.
NOTE: Needle decompression and chest tube placement CANNOT be performed at the same time.

Please let me know if this is not helpful and you need further assistance. Thank you for your continued support of our CAE simulation products.
__________________
V/r

Antonio Mendonça Rita
CAE Healthcare
Military Clinical Educator
Tel 941-536-2826 | Cell 941-685-6679
6300 Edgelake Drive, Sarasota, FL 34240

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:51 PM.