MMP Pacing message

[A. Kotesky]

Our MMP shows the following message repeatedly and constantly in the event log section of the screen: Pacing current was set to 20mA. Nothing has been done to the pacing current, so nothing should post to the event log. How do we make it stop showing this message, over and over again?
A. Kotesky

[Meri1]

do you have the latest version of muse? Also a small short or a bad circuit could cause this message.

[Jerry Andrews]

A. Kotesky,

If the problem persists please contact Customer Service at 1-866-462-7920 (ext. 3)

Regards,

Jerry